CHAINTECH 7VIL4 User Manual download pdf (Page 5)

Chapter 2

Chapter 2 Hardware Setup

If your motherboard has already been installed in your computer you may still need

to refer to this chapter if you plan to upgrade your system's hardware.

This motherboard is electrostatic sensitive. Do not touch without

wearing proper safety gadget and make sure to disconnect the power

cable from the power source before performing any work on your

motherboard. Not doing so may result in electrical shock!

2-1 Installing a CPU Processor for Socket A

The Socket A, designed for AMD® Athlon/Duron/XP processors, has been

incorporated as a standard motherboard specification. To insert your CPU into

Socket A please do the following:

1. Locate a cut edge on the top surface of the CPU close to one if it's corners. The

same corner will also be cut off, leaving a noticeable notch in the CPU's corner.

These markings indicate Pin 1 of the CPU.

2. Pull up the lever of Socket 462 so that it is perpendicular with the surface of the

motherboard. Gently insert the CPU with Pin 1 at the same corner of Socket 462

that contains the end of the lever. Allow the weight of the CPU to push itself into

place. Do not apply extra pressure as doing so may result in damaging your CPU.

Snap the lever back into place.

Installing an AMD® approved heat sink with cooling fan is necessary for

proper heat dissipation from your CPU. Failing to install these items may

result in overheating and possible burn-out of your CPU.

In order to boot up with a newly installed CPU, AC Power must be

switched off before installation.

Chapter 2

2-2 Setting Your CPU’s Performance:

Frequency Configuration:

If you install a CPU on this motherboard, you must set the [Front Side Bus

Frequency] JP3 according to your processor (See Section 2.4).

* CPU Speed = Multiplier x FSB Frequency

AMD (K7) Duron CPU

Model CPU Speed

FSB

Frequency

Multiplier Vcore

Cache

Micron

process

600 600 MHz 100 6.0 1.6V 64KB 0.18

650 650 MHz 100 6.5 1.6V 64KB 0.18

700 700 MHz 100 7.0 1.6V 64KB 0.18

750 750 MHz 100 7.5 1.6V 64KB 0.18

800 800 MHz 100 8.0 1.6V 64KB 0.18

850 850 MHz 100 8.5 1.6V 64KB 0.18

900 900 MHz 100 9.0 1.6V 64KB 0.18

950 950 MHz 100 9.5 1.6V 64KB 0.18

1.0G 1.0 GHz 100 10.0 1.6V 64KB 0.18

1.1G 1.1 GHz 100 11.0 1.6V 64KB 0.18

1.2G 1.2 GHz 100 12.0 1.6V 64KB 0.18

1.3G 1.3 GHz 100 13.0 1.6V 64KB 0.18

You do not need to make voltage settings because this board will automatically

set your CPU voltage.

1 2 3 4 5 6 7 8 9 10 ... 27 28

Comments to this Manuals

No comments

CHAINTECH 7VIL4 User Manual Page 5

Comments to this Manuals

Related products and manuals for Motherboards CHAINTECH 7VIL4